Special attention should be paid when using LED Grow Light

Install multiple lights at the same time
LED grow lights can produce target light output. It is possible by using optical elements. Therefore, you can focus on specific parts of the growth, so you can repeat for each part. If multiple parts are implemented, the plants will be protected. It will distribute the light to the greatest extent and can save money. A qualified lighting company can help you, if you ask, they will plan everything for you.

Set the light cycle
The life cycle is critical to the biological life of crops. The grower can manipulate it by increasing or decreasing the light time. Greenhouse growers can do this by using blackout curtains and additional lighting. During the growth stage of the plant, 18 hours of daylight are needed every day. The daily amount of light for nutritious crops is 17-18 hours.

Light intensity
Sufficient light levels required for flowering are 400 and 700 uMoles/m-2s. The light should be evenly distributed on the tree canopy. Since the lighting of the LED grow light is directional, please pay attention to it. Light less than 10 inches may cause bleaching.

SOG and SCROG technologies will help to form a flowering canopy depth between 12"-16", and light will reach all positions. If any flowers fall below this level, pruning will be done at the end of the second week. By the fourth week, remove all large fan blades so that they can be photographed. It is vital to ensure that the light path is consistent.

temperature
78F is the best temperature most appreciated by any factory. Then, the carbon dioxide level should be 360 PPM. You should monitor the root zone temperature. Air temperatures above 85°F require cooler dark air temperatures.

Nutrients

As the temperature increases, so does the nutrient concentration in the dry area. It can produce toxic levels in the root area. Therefore, reduce the nutrient concentration by 25-30%.